Evco EVBOX1 EVB1206 - Activating the service writing mode; Showing the errors about the data logging extension

EVCO S.p.A. EVBOX1 | Installation guide ver. 2.0 | Code 144BOX1E204
page 39 of 100
11.3.2 Activating the “service” writing mode
To activate the “service” writing mode, operate as follows:
1. Make sure the keyboard is not locked and no
procedure is in progress.
2. Press and hold the “DOWN” key 1 s: the display
will show the first available label.
3. Press and release the “UP” key or the “DOWN” key
to select “SEr”.
4. Press and release the “SET” key.
5. Press and release the “UP” key in 15 s to set “1”.
6. Press and release the “SET” key or do not operate
15 s: the display will show “SEr” flashing 4 s, after
which the device will quit the procedure.
11.4 Nomenclature of files
The following chart shows the meaning of the nomenclature of
files written with “HACCP” writing mode and generated daily
(for example the file “log001_2015_03_26.csv”).
PART MEANING
001
the device address (or parameter LA) has value
1
2015 the file has been generated on 2015
03 the file has been generated on March
26 il the file has been generated day 26
The following chart shows the meaning of the nomenclature of
files written with “HACCP” writing mode and generated montly
(for example the file “log001_2015_m03.csv”).
PART MEANING
001
the device address (or parameter LA) has value
1
2015 the file has been generated on 2015
m09 the file has been generated on March
The following chart shows the meaning of the nomenclature of
files written with “service” writing mode (for example the file
“log001_2015_0001.csv”).
PART MEANINH
001
the device address (or parameter LA) has value
1
2015 the file has been generated on 2015
0001 progressiv NUMBER
11.5 Showing the errors about the
data logging extension
To show the errors about the data logging extension, operate
as follows:
1. Make sure the keyboard is not locked and no
procedure is in progress.
2. Press and hold the “DOWN” key 1 s: the display
will show the first available label.
3. Press and release the “UP” key or the “DOWN” key
to select “Err”.
4. Press and release the “SET” key.
If the device has no error in its memory, the label “Err” will
not be shown.
5. Press and release the “UP” key or the “DOWN” key
to show the error code.
The following chart shows the meaning of the error codes.
CODE ERROR
FUL SD card space run out
Sd SD card non inserita o non riconosciuta
Pr7 auxiliary 2 probe error
Pr8 auxiliary 3 probe error
BAt data logger battery error
To quit the procedure:
6. Press and release the “ON/STAND-BY” key.