EVCO S.p.A.
EVBOX1 | Installation guide ver. 2.0 | Code 144BOX1E204
page 84 of 100
Alarm LED light
If the LED is on:
-
an alarm is in progress
If the LED is flashing:
-
compressor maintenance is required; see parameter C10
SD card status LED
If it is green firmly:
- no writing will be in progress and the data logger battery will fully be charged; the SD card is in the slot and can be
removed.
If it is red firmly:
- the writing will be in progress; the SD card is in the slot and can not be removed.
If it is green flashing:
- no writing will be in progress and the data logger battery will be charging; the SD card is in the slot and can be removed.
If it is red flashing:
- the SD card will not be in the slot.
14.2 Signal Descriptions/Explanations
The following table shows the meaning of the signal codes of the device.
CODE MEANING
Loc
-
the keyboard is blocked; see paragraph 6.11 “Keyboard locking/unlocking”
-
the work set point is blocked; see parameter r3
- - - - The operation requested is not available
To Next Page
Loading...
