Eventide ARGUS 5000 - Page 193

\J
The next page, DATA FORMAT SELECT, allows you
manually to select RS-232 parameters to match those of
the interfaced receiver. The Argus automatically selects
defaults to match the receiver settings, as described in
Appendix 2 of the reference manual. You should not
have to adjust these settings unless the receiver is being
used with an ELS or Fuel Flow system, or if the receiver
cannot be set to the defaults for some other reason.
ACFT. TYPE SELECT
AIRCRAFT TYPE
->FIXED WING
LANDING GEAR
LAND
|page||line|| chg || rtn f
DATA FORMAT SELECT
BAUD RATE
1200
WORD LENGTH
S
•ARITY
NONE
STOP BITS
1
PAGE
LINE
CHG
RTN
DATA FORMAT END
If you change the settings
and want to get back to the
defaults but don't remember
what they were, do the
following:
1: Select any other receiver model and Exit SETUP.
2: Re-enter SETUP and reselect the desired receiver.
This will restore the defaults.
3: Don't forget to exit SETUP so that the defaults will
"take."
The third SETUP page, at the left, tells the Argus what
type of aircraft it's installed in. The choices are FIXED WING and ROTARY WING.
Next, you select the landing capability of the aircraft from LAND, AMPHIBIOUS,
and WATER. The implications of these choices are discussed under the Seaplane
Bases/Heliport heading in the reference manual.
July 1999 Argus 5000/7000 Ver. 5.xx Reference Manual Part#141003 189