Everbilt HDCWJ10 - Page 18

18
Deep Well Installation (continued)
13
Connecting the brass elbow to the
pressure regulator
Thread the 1/4 in. disassembled elbow insert into the 1/4
in. hole on the side of the pressure regulator.
Slide the pressure tubing (attached with the pump pressure
switch or included in regulator kit) over the 1/4 in. brass
elbow and the pressure switch connector.
1/4 in. Pressure
Regulator Hole
Pressure
Switch
14
Connecting the PVC adapter to the
pressure regulator
Wrap thread tape around the threads of a 3/4 in.
MNPT x 1 in. slip PVC adapter (sold separately).
Thread the adapter into the pressure regulator.
15
Connecting a (MM) 10 in. tank tee
to the pressure tank (tank tee size
may vary based on tank size)
Wrap all threads on tank tee with thread tape.
In order for the pump and the pressure tank (sold separately)
to operate properly, the pressure tank must be drained of all
water BEFORE INSTALLING TO THE PUMP.
Thread a (MM) 10 in. tank tee (sold separately) or
recommended size based on pressure tank size.
On the top of the tank tee that faces the pump system, plug
the outlet with a (NN) 1/4 in. plug (sold separately).
On the opposite end of the tank tee install a (OO) pressure
gauge (sold separately) onto the outlet of the tank tee.
On each side inlet of the tank tee, thread a (CC) 1 in. female
PVC adaptor.
On the front of the tank tee that has the 1/4 in. plug, thread a
(DD) 1/2 in. relief valve (sold separately).
On the front of the tank tee that has the pressure gauge,
thread a (GG) 1/2 in. drain valve (sold separately).
.ni 1 )CC )CC(
Fe
PVC
Adaptor
Tank
(O0) Pressure Gauge
(GG) 1/2 in.
Drain Valve
2/1 )DD )DD(
Relief Valve
.ni 1 )CC )CC(
Fe
PVC
Adaptor
(NN) 1/4 in. Plug
01 )MM )MM(
Tank Tee