Everglades 285 CC - After Launching; Reactivating the Boat after Storage; Recommissioning

137
Seasonal Maintenance
14.3 Recommissioning
WARNING
DO NOT OPERATE THE BOAT UNLESS IT IS COMPLETELY
ASSEMBLED. KEEP ALL FASTENERS TIGHT. KEEP
ADJUSTMENTS ACCORDING TO SPECIFICATIONS.
Notice:
It is important and recommended that the
tting out procedure for the marine gear be
done by a qualied service person. Read the
engine owner’s manual for the recommended
procedure.
CAUTION
BEFORE LAUNCHING THE BOAT, MAKE SURE THE HULL
DRAIN PLUG IS INSTALLED.
Reactivating The Boat After Storage:
• Charge and install the batteries.
• Install the drain plug in the hull.
• Check the engines for damage and follow the
manufacturer’s instructions for recommis-
sioning.
• Check the mounting bolts for the engines to
make sure they are tight.
• Perform all routine maintenance.
• Check all hose clamps for tightness.
• Pump the antifreeze from the fresh and raw
water systems and ush several times with
fresh water.
• Check and lubricate the steering system.
• Clean and wash the boat.
• Install all upholstery, cushions and canvas.
After Launching:
• Carefully check all water systems and the
engine bolts for leaks. Operate each system
one at a time checking for leaks and proper
operation.
• Check the bilge pump manual and automatic
switches.
• When each engine starts, check the cooling
system port below the engine cowling for a
strong stream of water. This ensures that the
cooling pump is operating.
• Carefully monitor the gauges and check for
leakage and abnormal noises.
• Operate the boat at slow speeds until the en-
gine temperature stabilizes and all systems
are operating normally.