71
Electrical System
Windlass Switch
Power Port
Seakeeper Control Panel
Windlass Switch
A three position momentary switch located in the
windlass compartment that controls the windlass.
The middle position is OFF. Press and hold the
switch UP to raise the anchor. Press and hold
the switch DOWN to lower the anchor. The switch
automatically returns to the middle (OFF) position
when it is released.
The primary windlass circuit is protected by a
heavy duty circuit “push to reset” breaker located
in a digital control module below the helm. An-
other circuit breaker in the digital switching control
module protects the helm windlass switch circuits.
Seakeeper Display Panel (Optional)
Located in the starboard compartment below the
helm seats. The display is the user interface to
the Seakeeper. It is used to start, operate, moni-
tor and shutdown the Seakeeper. Sensors, alarms
and shutdowns are provided to allow unattended
operation.
The display also provides information in the event
of an alarm. Alarms cause precession to stop and
the Seakeeper to start coasting down.
Refer to the Seakeeper operation manual for more
information.
Power Ports (Optional)
A 12 volt power port is located below the gunnel on
each side of the cockpit. The power ports provide
a 12 volt DC power connection for down riggers or
electric reels. Each power port requires a special
twist lock plug to be installed on the power cord
of the accessory. One plug for each port was
included with your boat. Additional plugs can be
ordered through your dealer.
The power ports are protected by fuses located in
the accessory fuse panels behind the helm.
To Next Page
Loading...
