Eversys Enigma E'2c/Classic - Page 101

Steam wand | Steam arm V2
1. Switch o (page 68) at the main power switch.
2. Remove the nozzle (1).
3. Wash the nozzle with soft soap and clean water using a soft brush (2).
4. Tighten the nozzle (3).
1
2
3
Steam wand | Steam arm V1
1. Switch o (page 68) at the main power switch.
2. Remove the nozzle (1).
3. Ensure to not remove (2) the white seal.
4. Wash the nozzle with soft soap and clean water using a soft brush (3).
5. Tighten the nozzle (4).
6. Check that there is no gap between the seal and the nozzle (5).
3
1
4
2
5
For more information about steam wand versions, refer to TI-154 Enigma /
E'line - Steam Wand V2 that is available under the e'Support center (https://
support.eversys.com/hc/en-us).
Care
02.01.2023 Page 101 of 172 © Eversys S.A.