254
POWERHEAD
POWERHEAD INSTALLATION
Install rear shroud and flywheel cover.
Install the lower engine covers. Refer to LOWER
COVER SERVICE on p. 91.
IMPORTANT: Perform the following procedures
before returning outboard to service:
• Index all spark plugs. Refer to Spark Plug
Indexing on p. 84.
• Adjust timing pointer and check engine timing.
Refer to TIMING ADJUSTMENTS on p. 154.
• Use Evinrude Diagnostics software to start pow-
erhead break-in oiling. Refer to Powerhead
Break-In on p. 106.
• Prime oiling system. Refer to Oiling System Oil
Supply Priming on p. 61.
• Run outboard and check for water, fuel, or oil
leaks.
• Make sure engine reaches correct operating
temperature and does not overheat.
005248
To Next Page
Loading...
