Setting up Your Fiber Inspection Probe and ConnectorMax2 Mobile
Fiber Inspection Probe 21
Connecting or Disconnecting the Wireless Probe
You have to disconnect the probe first if you want to perform the following:
Work with another probe
Use the probe with another smart device
Share files with third-party applications. Since the third-party
applications do not have Internet access, the files cannot be
transferred and they are buffered. See Transferring Results With
Third-Party Applications on page 93 for details.
Upon connecting the wireless probe, geolocation information may be
retrieved and associated to individual tests if the geolocation service is
available on your smart device. When you disconnect the probe and with
an Internet access, the application can even pinpoint the location of the
measurement on a map.
To connect the wireless probe:
1. Ensure the power saving mode is disabled on your smart device.
2. Turn on the probe by pressing the ON button.
3. Ensure the Wi-Fi is activated on your smart device.
4. Go to the device Settings.
5. Select Wi-Fi.
6. Select the wireless probe you want to work with.
7. Upon starting the ConnectorMax2 Mobile application the probe is
connected automatically.
Note: When a wireless probe is selected, the 3G, 4G and LTE data
communications are disabled automatically.
Note: The probes are identified by their serial numbers and type.
Note: The probe can be selected from the Wi-Fi configuration on the smart
device.
To Next Page
Loading...
