Setting up Your Fiber Inspection Probe and ConnectorMax2 Mobile
Fiber Inspection Probe 37
Setting up Autonaming
3. Move the increments from the Inactive Increments to the Active
Increments space by tapping . You can remove the identifiers by
tapping . You can also move the identifiers, with the drag and drop
gesture, from the Active Increments to the Inactive Increments space
by tapping and holding .
Note: Only the identifiers with values are displayed.
4. When an increment is moved to the Active Increments, enter the start,
stop and increment values as desired by tapping the row
corresponding to the identifier that you want to modify.
Note: To decrement values, the start number must be higher than the stop
number.
5. Tap Done to confirm your new settings and to return to the main
window.
The new settings will apply the next time you perform a capture.
Setting up Autonaming
The autonaming feature is useful to make a relevant naming scheme for
your tests. This also ensures that you do not overwrite files by mistake. You
can select which item goes in the file name, as well as the type of separator
you want to use in between.
A preview is available to show you the final output of the file name.
To Next Page
Loading...
