Inspecting Fiber Ends
Fiber Inspection Probe 83
Analyzing Captures
Analyzing Captures
With the capture analysis option, you can perform automated pass/fail
analyses according to the criteria you have set.
Depending on the fiber probe that you have, you may have access to the
following features:
Auto centering: displays the fiber in the middle of the image. It is
compatible with all connector types and fibers with a cladding of
125 μm. The auto centering is enabled only in high magnification.
Working with the auto centering feature can be useful with standard
connectors. The auto centering is automatically activated when the
auto focus is enabled.
Note: The auto centering feature is not available for FIP-425B and FIP-435B
MF-Ready probes when testing multifiber connectors.
Auto focus: focuses on the connector image. It is enabled only in high
magnification. The auto focus is only possible in Live Video mode, and
if the focus is not done manually. It starts automatically when you insert
an optical fiber connector. For more information, see Fiber Inspection
Probe Tip Compatibility Chart on page 121.
Note: The auto focus feature is not available for FIP-425B MF-Ready probes when
testing multifiber connectors.
To Next Page
Loading...
