Inspecting Fiber Ends
72 FIP-400B
Inspecting Multiple Fiber Ends (MF-Ready Probes Only)
11. If the connector is dirty, remove it from the probe, clean it and
reinspect it.
12. To perform the first capture (out of three), proceed as follows:
12a.Using the trigger, slide the movable part of the inspection tip
towards the nozzle until it stops.
12b.Once you are satisfied with the inspection, tap .
OR
Press the Fiber Inspection Probe handset button.
Note: If you are not satisfied with capture number one, you can take it again.
When the first capture is done, the application automatically switches to
. Tap to perform capture number one again.
Inspection tip (movable part)
To Next Page
Loading...
