Communicating Through TCP/IP Over Telnet
460 FTB-1v2 and FTB-1v2 Pro
Executing SCPI Commands Over Telnet
2. Enter the desired SCPI commands as follows:
For a single SCPI command: Type or copy the desired command in
the Telnet editor window, and then press ENTER to execute it.
For multiple SCPI commands: Copy the desired commands from
any script file, enclose them in a BEGIN and END block in the
Telnet editor window, and then press ENTER. For more
information, see Internal Commands of the TCP/IP over Telnet
Protocol on page 463.
3. Click to close the session.
To Next Page
Loading...
