Turntable control SmartTurn
Index
Dok-ID:EXPERT-0003-EN-2011 69
8 Index
0
0-position optimization ........................................ 20
B
Brake wear monitor ............................................ 22
C
Change mode (changed rotary direction) ........... 62
Changed lock angle ............................................ 63
Commissioning ................................................... 49
Commissioning sequence .................................. 50
Comply with the instructions in the Installation and
Operating Manual - Turntables ......................... 9
Connecting ......................................................... 33
Connection - power unit ...................................... 41
Connections ........................................................ 27
Connections - control unit ................................... 44
Contacts................................................................ 8
Continuous mode ......................................... 17, 47
Control unit ......................................................... 27
Copyright .............................................................. 7
Customer service .................................................. 8
D
Description - PLC signals ................................... 35
Device description .............................................. 15
Device settings - control unit .............................. 24
E
Electrical installation ........................................... 34
End of lock angle reserve reached (end of lock
angle reserve) ................................................. 56
Environmental protection .................................... 12
F
Faults .................................................................. 53
Functional description ......................................... 16
Functional principle diagram............................... 19
G
Guarantee ............................................................. 8
I
Input forward and backward on (Both Inputs On)
........................................................................57
Inputs ..................................................................35
Installation and commissioning ...........................32
Intended use .......................................................11
Internal device fault (secure state) .....................65
L
Liability .................................................................. 7
M
Mounting instructions ..........................................33
O
Optional components and accessories ...............31
Outputs ...............................................................37
Overrun forward / backward ...............................53
Overrun monitor ..................................................23
Overview .............................................................14
P
Personnel
commissioning ................................................32
faults ................................................................53
installation .......................................................32
requirements ...................................................10
Pin assignment - control unit ..............................28
Pin assignment sensor .......................................30
PLC programming ...............................................46
R
Re-commissioning in the plant............................52
Re-commissioning sequence..............................52
Replacement parts ................................................ 8
Responsibility of the customer .............................. 9
Responsibility of the customer .............................. 9
Reverse mode ............................................. 17, 46
S
Safety .................................................................... 9
To Next Page
Loading...