Turntable control SmartTurn
General Information
Dok-ID:EXPERT-0003-EN-2011 7
1.3 Disclaimer
All information and instructions in this operating manual have been
provided under due consideration of applicable guidelines, the
current state of technology, as well as our many years of
experience.
The manufacturer assumes no liability for damages due to:
Failure to heed the instructions in the manual
Non-intended use
Deployment of untrained personnel
Unauthorized conversions
Technical changes
Use of non-approved replacement parts
The actual scope of delivery can vary from the explanations and
graphic representations provided in this manual in the case of
special versions, if supplemental order options are desired, or on
the basis of the latest technical changes.
In all other respects the agreed obligations in the delivery contract,
the general terms and conditions, as well as delivery conditions of
the manufacturer, and the statutory regulations valid at the time the
contract was concluded, apply.
We reserve the right to make changes in the interest of
enhancements and improvement of the performance
characteristics.
Pos: 1.7 / St and ard modul e/1 All ge mein es/ 1.4 U r heb ersch utz @ 0\ mod_1192544227602_38.doc @ 146
1.4 Copyright
Treat this operating manual with confidentiality. It has been
exclusively prepared for personnel working with the device.
Provision of the operating manual to third-parties without written
consent from the manufacturer is prohibited.
NOTE!
The content, texts, drawings, graphics, and other
presentations are protected by copyright and are
subject to commercial property rights Any improper
use is punishable.
Duplication in any form - including excerpts - as well as exploitation
and/or communication of the content are not permitted without a
written declaration from the manufacturer. Actions to the contrary
make damage compensation mandatory. We reserve the right to
enforce additional claims.
To Next Page
Loading...