Need help?Do you have a question about the Extech Instruments 382100 and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Display | LCD |
| Max Voltage (AC/DC) | 600V |
| Max Current | 10A |
| Frequency Measurement | 10MHz |
| Temperature Measurement | Yes |
| Data Hold | Yes |
| Auto Power Off | Yes |
| DC Voltage | 600V |
| AC Voltage | 600V |
| DC Current | 10A |
| Resistance | 40MΩ |
| Diode Test | Yes |
| Continuity | Yes |
| Frequency Range | 10Hz to 10MHz |
| Battery Type | 9V |
| Digit Display | 4000 count |
Highlights key capabilities: LCD, parameters, accuracy, safety rating, and data logging.
Outlines the manufacturer's warranty terms and conditions for the instrument.
Details critical safety precautions, warnings, symbols, and environmental operating limits.
Covers circuit, display, measurement types, connections, ranges, and safety standards.
Specifies ACV, ACA, Power Factor range, resolution, and accuracy for electrical measurements.
Describes the power-on initialization screen and the main measurement display interface.
Details the function of each key on the instrument for operational control.
Guides on setting a folder name for data logging on the SD card.
Explains how to set a file name for recorded data on the SD card.
Details configuring the sampling time or data logging rate for the SD card.
Provides instructions for deleting files from the SD memory card.
Explains the process of formatting the SD card to erase all data.
Guides on setting the Potential Transformer (PT) ratio for accurate measurements.
Details setting the Current Transformer (CT) ratio for accurate measurements.
Explains enabling or disabling the audible beeper function.
Describes selecting the decimal format (period or comma) for displayed numbers.
Guides on selecting the correct clamp type (200A or 1200A) for the instrument.
Details configuring parameters for RS-232 serial data output.
Explains setting the instrument's internal clock and date.
Instructions for exiting setup and returning to the measurement screen.
Defines SD card terms: USE SIZE, FREE SIZE, TOTAL SIZE.
Explains using the RESET key to reboot the instrument.
Provides steps for single-phase, two-wire power measurements.
Details the procedure for single-phase, three-wire power measurements.
Guides through three-phase, three-wire power measurements.
Explains steps for three-phase, four-wire power measurements.
Describes measurements using Current Transformers (CT) and Potential Transformers (PT).
Instructions for starting, stopping, and managing data logging using the SD card.
Explains using the Data Hold feature to freeze readings on the display.
Information on using the backlight key to turn the LCD backlight on or off.
Details using the Current (A) RANGE key for auto or manual range selection.
Describes the low battery indicator and its impact on accuracy.
Provides definitions for electrical terms and measurement parameters.
Instructions for properly cleaning the instrument using a dry cloth.
Guides on replacing instrument batteries when the low battery indicator appears.
Details the protocol and settings for connecting the meter to a PC via RS-232.
Provides instructions for downloading data from the SD card to a computer.
To Next Page