5. When power is connected, verify that the SYS LED on the port extender turns green.
If the SYS LED does not turn green, verify that the power source is on and the connection was made
properly.
6. Optionally, connect the port extender to a redundant power source, depending on the model.
The following mounting kits are available for non-PoE V300 models:
Table 26: V300 Mounting Kits
Kit part number Description
XN-2P-RMTKIT-1CS-001 Single rack mount kit
XN-2P-RMTKIT-2CS-001 Dual rack mount kit
XN-DIN-MT-001 DIN Rail mount kit
XN-MTKIT-CS-001 Replacement surface mount kit
XN-PS-MT-001 PSU mount kit
For additional installation options, including non-PoE V300 Mounting Kit installation, see the following
topics:
• Install a V300 Virtual Port Extender on a Wall on page 88
• Install a V300 Virtual Port Extender Under or on a Table Surface on page 91
• Install a V300 Virtual Port Extender in a VESA Mount on page 93
• Install a V300 in a Single Rack Mount on page 95
• Install a V300 in a Dual Rack Mount on page 98
• Install a V300 in a DIN Rail Mount on page 101
• Install a V300-8P-2T-W Model in a Single or Dual Rack Mount on page 104
• Installing a V300-8P-2T-W Model in a DIN Rail Mount on page 105
Install a V300 Virtual Port Extender on a Wall
The following tools and materials are required to install a V300 Virtual Port Extender to a wall:
• ESD-preventive wrist strap
• M3.5 #2 Phillips screwdriver (magnetic screwdriver recommended)
• M4 #2 Phillips screwdriver (magnetic srewdriver recommended) for non-PoE models
Note
The mounting surface, item, and hardware must be able to support the extender in all
environmental conditions. The mounting surface must also be flat.
Typical installation for the V300-8P-2T-W model include wall or table installations, in addition to VESA
mounting.
There are several orientations for installation on a wall. To install the V300-8P-2T-W model on a wall:
1. Attach the short brackets to both sides of the extender
The orientation for wall mounting should be front panel facing down.
Install a V300 Virtual Port Extender on a Wall
Installing Expansion Modules
88 ExtremeSwitching 5520 Series Hardware Installation Guide
To Next Page
Loading...
Need help?
General
