Extron electronics FOX3 T 201 - Audio Configuration; Audio Embedding; Audio Input Gain; Audio Input Configuration

FOX3 T 201 Transmitter • Installation and Operation 16
Audio Configuration
Audio Embedding
The FOX3 supports a single audio signal to pass LPCM-2CH. The audio input sent over
the fiber output can be configured via PCS (see the FOX3T201 PCS Help File) or SIS
command (see Input audio selection on page25). Select digital, analog, or auto.
Audio Input Gain
Adjust the transmitter gain level for the analog audio input via PCS (see the FOX3T201
PCS Help File). The analog audio input can be adjusted from -18 dB to +24dB in 1 dB
steps.
Audio Input Configuration
Select the audio on the input of the transmitter via PCS (see the FOX3T201 PCS Help File)
or SIS command (see Input audio selection).
The audio input options are:
• Auto (default) — The transmitter selects between digital and analog audio based on the
digital audio input signal.
• Digital audio is selected when embedded audio is present on the HDMI input.
• Analog audio is selected when digital audio is not detected.
• Force Digital — Digital embedded audio is passed to the local HDMI and fiber output.
• Force Analog — Analog audio is passed to the local HDMI and fiber output.
Audio Mute
Mute audio on the Loop Out, HDMI output, and analog audio output individually via PCS
(see the FOX3T201 PCS Help File) or SIS commands (see Audio mute — Digital Output
or Analog Audio Out on page22).