IN1804 Seamless Scaling Switchers • Internal Web Pages 100
During the updating process, a window appears in the middle of the screen, showing
messages giving the progress of the update: Initializing, Installing the
Firmware, and Rebooting Device.
Figure 57. Firmware Update Message Window
When the update is completed, the message window closes and the message
Firmware Upload Complete appears near the top of the screen. The new firmware
filename appears beside Version in the Firmware panel of the web page.
Network Settings Panel
In the Network Settings panel (see figure 49,
7
, on page 94), you can set the IP
address, subnet mask, and gateway address for your IN1804, and turn DHCP on and off.
You can also view the MAC address of the unit. To set the IP addresses:
1. Click Edit in the lower-left corner of the Network Settings panel. The EDIT Network
Settings screen opens.
Figure 58. Edit Network Settings Screen
57
58
To Next Page
Loading...
