Extron electronics IN1804 Series - Using the Menu Screens

IN1804 Seamless Scaling Switchers • Operation 24
Using the Menu Screens
Figure 18. On-screen Menu Example
To open the on-screen menu:
1. Connect a display device to an HDMI output connector (see Rear Panel Connections
on page 10).
2. Press the Menu or Enter button to open the on-screen menu.
To navigate the on-screen menu:
1. Press the
>
and
<
buttons to move through the submenus (left) panel. The table on
the previous page shows the eight submenus and the items they contain.
2. Press Enter or  to select a submenu and display its items in the right panel.
3. Press the
>
and
<
buttons to move the blue
selection border to the desired submenu item (see
the example at right).
4. Press Enter to select the item.
5. Press the  button to return to the list of submenus in the left panel.
To adjust the settings of a submenu item:
1. Navigate to an adjustable submenu item and press the Enter or  button to select the
item.
2. Press the  and  buttons to adjust the setting or select a specific adjustable setting
within the selected submenu item.
If the selected submenu item has multiple adjustable settings, press the
>
and
<
buttons to select a value.
3. Press the Enter button to accept the new value.
NOTE: To cancel a change, press the  button to return to the submenu list (left
column) without pressing Enter. Then, press the
>
or
<
button to move to a
different submenu.
18