Extron electronics IN1804 Series - HDMI Connections

IN1804 Seamless Scaling Switchers • Installation 17
HDMI Connections
Use an Extron LockIt cable lacing bracket to secure HDMI cables to the device.
NOTE: The HDMI device must have an HDMI connection mounting screw for this
bracket to be used.
To securely fasten an HDMI cable to a device:
3
3
4
1
2
Figure 12. Mounting a LockIt Cable Lacing Bracket
1. Plug the HDMI cable into the panel connection (see figure 12,
1
).
2. Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it (
2
). The screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then tighten
the screw to secure the bracket (
3
).
4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket as shown.
5. While holding the connector securely against the lacing bracket, use pliers or a similar
tool to tighten the tie wrap, then remove any excess length (
4
).
ATTENTION:
• Do not overtighten the HDMI connection mounting screw. The shield to which
it is fastened is very thin and can easily be stripped.
• Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
12