IN1804 Seamless Scaling Switchers • Operation 26
Quick Setup Submenu
Figure 20. Quick Setup Submenu
The Quick Setup submenu is displayed by default when the OSD is first opened, and
provides quick access to frequently-used settings. This submenu contains the following
items, which also appear on other submenus in the system:
• INn: Input Mode — Displays the format of the selected input. For HDMI or DVI inputs,
this field is read-only. For twisted pair inputs, press the
>
and
<
buttons to select DTP
or XTP.
• INn: EDID — Press the
and
buttons to select the resolution or the rate list. Press
the
>
and
<
buttons to navigate through the selected list. Selecting Auto (the default)
from the resolutions list matches the current output resolution. There are five custom
options, prefaced by C1 through C5.
• Output Rate — Press the
>
and
<
buttons to select from a list of output resolutions
and refresh rates (see Output Rate on the Output submenu on page 32). There are
five custom options, prefaced by C1 through C5. The default setting is 1080p @ 60 Hz.
• Audio Mute — Press the navigation buttons to mute (On) or unmute (Off) the audio.
You can also select Analog to mute analog audio or Digital to mute embedded
digital audio.
• Test Pattern — Press the navigation buttons to select an available test pattern to
display or to turn a test pattern off (see Test Pattern on the OSD Advanced submenu
on page 37). The available test pattern selections are Crop, Alternating Pixels,
Crosshatch, Color Bars, Grayscale, and Audio Test (pink noise). The default
setting is Off.
• DHCP Mode — Press the
>
and
<
buttons to enable (On) or disable (Off) DHCP
mode.
• IP Address — Press the
and
buttons to switch between octets. Press the
>
and
<
buttons to change the value of a selected octet.
20
To Next Page
Loading...
