Extron electronics IN1804 Series - RS-232 Panel

IN1804 Seamless Scaling Switchers • Internal Web Pages 101
2. Edit the network settings as desired:
• DHCP — Click the DHCP button (see figure 58,
1
, on the previous page) to toggle
DHCP on and off. When DHCP is enabled (On), the unit configures its IP address
and other network settings from the DHCP server. The default is Off.
• IP Address, (
2
), Subnet mask (
3
), and Gateway address (
4
) — To set any
of these addresses, click in the desired field and enter the address.
3. When finished editing, click Save to confirm your changes or Cancel to close the
window without making changes. You can also close the window by clicking the X in the
upper-right corner of the screen.
NOTE: If DHCP is being enabled, the web page attempts to redirect and connect to the
unit via the unit name (TCP/IP hostname). If a static IP address is being set, the web
page attempts to connect to the new IP address.
RS-232 Panel
The view-only RS-232 panel (see figure 49,
8
) displays the RS-232 protocol for the
IN1804 serial port. The settings are:
• Baud rate — 9600
• Parity Bit — N (none)
• Data bits — 8
• Stop bits — 1