IN1804 Seamless Scaling Switchers • Operation 32
Output Submenu
Figure 25. Output Submenu
The Output submenu enables you to configure the output resolution, refresh rate, HDMI
format, and HDCP notification. You can also select a user-loaded logo image to display and
position it on the screen.
NOTE: Figure 25 shows the Output submenu of the IN1804 DO and DI/DO models.
The IN1804 DI and standard models have HDMI 1A Format as the second option
(instead of TP 1A Format) and – – – – as the third option (instead of TP 1A Mode).
• Output Rate — Select this item to specify the output resolution and refresh rate. The
IN1804 Series switchers have a range of resolutions from which to choose (see the
Output Resolutions and Rates table on the next page for the available settings). The
available rates depend on the selected resolution.
Five custom user-defined output rate slots are also available to be defined via SIS
commands or via the Capture EDID item on the Input menu. If a custom EDID has not
been captured from a display device or has not been uploaded to the unit, these slots
default to 1080p @ 60 Hz.
When a resolution is applied to a user-defined EDID slot, its name is displayed in the
Output Resolution panel in the format cn: nnnnxnnnn @ nn (XXX). An example would
be C1: 1280x780 @ 60 Hz (EXN) (the last three letters in parentheses represent the
name of the manufacturer of the device).
NOTE: The five custom, user-defined output rates default to 1080p @ 60 Hz when
no custom EDID is captured or uploaded.
25
To Next Page
Loading...
