Extron electronics IN1804 Series - Powering up; Selecting an Input; Using the On-Screen Menu System; Menu Selection Buttons

IN1804 Seamless Scaling Switchers • Operation 22
Powering Up
When power is applied to the switcher, the Input 1 LED blinks prior to the full boot-up of the
product. When boot-up is complete or nearing completion, each of the input LEDs lights,
one at a time, in ascending order (1 through 4).
Next, each of the signal status LEDs lights in the same manner. When boot-up is complete
and after the LED lighting sequences occur, normal operation begins.
Selecting an Input
Press any of the four input buttons on the front panel to select an input. The green LED for
the selected input lights.
You can also select inputs via the Contact/Tally ports. See Wiring the Contact/Tally
Connectors on page 19 for more information.
Using the On-Screen Menu System
The OSD menus are used primarily for the initial setup of the device. The on-screen menu
presents configuration options on a local monitor and can be adjusted with front panel
controls.
NOTE: The on-screen menu has a default timeout of 60 seconds.
Menu Selection Buttons
MENU
ENTER
HOLD FOR 720p/1080p
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5
6
6
6
Figure 17. Menu Selection Buttons
• Menu button — Press the Menu button (see figure 17,
1
) to activate or exit the
on-screen menu, deselect a submenu, or cancel a pending change.
• Enter button — Press the Enter button (
2
) to access the on-screen menu, select
submenus, or submenu items, or to accept pending changes.
• Navigation buttons — Press these buttons to navigate through the menu system:
• Press the
>
(Up) (
3
) or the
<
(Down) (
4
) arrow button to navigate submenus or
submenu items.
• Press the  (Right) arrow button (
5
) to access currently selected submenus or
submenu items.
• Press the  (Left) (
6
) arrow button to exit currently selected submenus or
submenu items. You can also use the navigation buttons to adjust settings
according to specific setting directions.
17