Extron electronics IN1804 Series - Audio Submenu

IN1804 Seamless Scaling Switchers • Operation 35
• Logo Position — This item lets you specify a position for the selected logo on the
display relative to the upper-left corner of the logo. The default is H: 0000 V: 0000.
To position the logo:
1. Press the Enter button to select Logo Position from the Output submenu. The
Logo Position item appears as a single field on the OSD.
2. Press the

or  buttons to select the horizontal position of the logo, and the u
or  button to select the vertical position.
3. Press the Enter button to confirm your selections.
4. Press  to return to the Output submenu.
Audio Submenu
Figure 26. Audio Submenu
The Audio submenu allows you to configure the audio settings. To use this submenu, press
Enter to select this item, then press the

or  button to step through the selections.
• Audio Mute —Select this item to mute and unmute the output audio. You can make
the following audio mute selections:
• Off — Audio output is not muted (default).
• Analog — Mutes the analog audio output only.
• Digital — Mutes the embedded digital audio output only.
• On — Mutes both the analog and the embedded digital audio outputs.
26