Extron electronics IN1804 Series - Page 78

IN1804 Seamless Scaling Switchers • SIS Configuration and Control 70
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Presets
Input Presets
Values Saved in Input Presets
Preset Name Detail
Audio Gain and Attenuation H Image Position
Film Mode Detection V Image Position
Contrast H Image Size
Brightness V Image Size
Recall preset
2*
X2^
.
2Rpr
X2^]
Recall input preset
X2^
for the selected
input.
Save preset
2*
X2^
,
2Spr
X2^]
Save input preset
X2^
for the selected
input.
Delete preset
E
X2*
X2^
PRST
}
PrstX2*
X2^]
Clear input preset
X2^
and set its name
to [unassigned].
Input Preset Name
Write name
E
2*
X2^
,
X1$
PNAM
}
Pnam2*
X2^
,
X1$]
Set the name of input preset
X2^
to
X1$
.
View name
E
2*
X2^
PNAM
} X1$]
View the name (
X1$
) of input preset
X2^
.
NOTE: Unsaved input presets are shown as [unassigned]. To restore a default input preset name (with the format
Input Preset nnn with leading zeros), enter a single space character for
X1$
. These entries are valid only for previously
saved presets.
Auto Memories
Enable
EX!
*1AMEM
}
Amem
X!
*1
]
Set Auto Memory to On (default state)
for input
X!
. Settings are automatically
stored as presets. Previous settings for
the incoming signal are recalled.
Disable
EX!
*0 AMEM
}
Amem
X!
*0
]
Set Auto Memory to Off for input
X!
.
Manual recall of input presets is required
to configure the input.
View setting
E
1 AMEM
} X1) ]
Verbose modes 2 and 3:
Amem
X!
*
X1) ]
View current Auto Memory status
X1)
for input
X!
.
KEY:
X1)
= On or off, enable or disable
0 = Off or disabled
1 = On or enabled
X1$
= Preset name (text label)
Up to 32 characters, excluding , (comma) ,*, and
|
.
X2^
= Input preset number
1 through 128. Response is three digits, padded with zeros.