version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 38
INSTALLATION OF COOL GAS GENERATOR(S)
Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified and
trained personnel, familiar with the product and its documentation (product datasheet,
operating manual).
1. First check if the Cool Gas Generators are not visibly damaged
2. Inspect if all the tamper evident stickers are still in place
3. Do not remove the transportation nozzle from Generator!
Figure 16 Removing foil
4. Remove the adhesive foil / sticker of the gasket before placing the generator
5. Remove screws of top cover
6. Remove the top cover and disconnect the earth cable to the top cover.
To Next Page
Loading...