INSTRUCTION MANUAL MT, MA2, MK2, M10 DRIVE UNIT
10
Drive arm
3
Install the drive arm by removing the bolt and
washer / retaining ring on the output shaft from
the drive unit and pressing the arm into place.
en reinstall the bolt and washer / retaining
ring.
Gate mounting
4
Screw the gate mounting into place using two M8 bolts according to the assembly
drawing.
Link arm
5
Position the link arm
between the drive arm and
gate mounting. Screw it
into place using M12 bolts
and washers.
6
Adjust it by undoing one bolt and then screwing the arm out
or in at the gate mounting.
To Next Page
Loading...
