INSTRUCTION MANUAL MT, MA2, MK2, M10 DRIVE UNIT
11
• Top mounting with limited lateral space
Bracket & mounting plate
1
Centre the plate horizontally above the gate
opening. Height dimensions in accordance with
a separate assembly drawing. en weld the
motor plate onto the mounting plate.
Drive arm
2
Install the drive arm by removing the bolt and
washer / retaining ring on the output shaft from
the drive unit and pressing the arm into place.
en reinstall the bolt and washer / retaining ring.
Gate mounting
3
Screw the gate mounting into place using two M8 bolts according to the assembly
drawing.
To Next Page
Loading...
