FAAC DAAB MT - General Top Mounting Procedures; Bracket & Mounting Plate Installation; Drive Arm and Gate Mounting

INSTRUCTION MANUAL MT, MA2, MK2, M10 DRIVE UNIT
20
• Top mounting
Bracket & mounting plate
1
Positioned centrally above the gate
opening.
Dimensions and mounting according
to the point entitled "Mounting
plate" in the chapter "Installation and
commissioning; General installation"
2
Centre the plate horizontally above
the gate opening. Height dimensions
in accordance with a separate assembly
drawing. en weld the motor plate
onto the mounting plate.
Drive arm
3
Install the drive arm by removing the bolt and
washer / retaining ring on the output shaft from
the drive unit and pressing the arm into place.
en reinstall the bolt and washer / retaining
ring.
Gate mounting
4
Screw the gate mounting into place using two M8 bolts according to the assembly
drawing.