FAAC DAAB MT - Drive Unit Operation and Disengagement; Adjusting Limit Positions; Quick Release and Disengagement

INSTRUCTION MANUAL MT, MA2, MK2, M10 DRIVE UNIT
25
• Adjusting the drive unit
!
WARNING
Disengage the door/gate at the drive arm and ensure that it can be
easily operated manually.
!
DANGER
Before all safety devices are in operation and are correctly calibrated
only hold to run operation is permitted.
Ensure that the door/gate opens and closes to the correct position,
i.e. that it does not press too hard on the surround or does not open
completely. e leaves of the gate must line up with each other in
the closed position which is important if there is a solenoid lock or
striker. Adjust the limit positions by turning the limit cams on top
of the drive unit output shaft. e upper cam is for adjusting the
closed position and the lower for the open position.
• Disengagement
Quick release
Turn the release handle a half turn to disengage the door.
Release handle
Unscrew the release handle from the drive arm mounting to disengage the door.