FAAC DAAB MT - MA2;MK2 Drive Unit Installation Procedures; Installing and Securing the Drive Unit

INSTRUCTION MANUAL MT, MA2, MK2, M10 DRIVE UNIT
15
• Installing the drive unit
Installation of the drive unit is common to all types of mounting.
e motor is located in dierent holes depending on the angle at which it is positioned. Viewed from the left this is 90, 100
and 110 degrees. e angle to be used is indicated in the assembly drawing supplied with the unit.
1
Insert the drive unit in the bracket.
2
Tighten one bolt.
3
Turn the drive unit to make the installation
of power and limit position cables easier.
4
Turn back the drive unit and tighten the
other bolt.