INSTRUCTION MANUAL MT, MA2, MK2, M10 DRIVE UNIT
12
Mounting plate for the swing arm bracket
4
Position the mounting plate for the swing
arm bracket according to the point entitled
"Mounting plate" in the chapter "Installation
and commissioning; Side installation".
5
Screw the bracket into place on the mounting
plate using four M10 bolts. Adjust the swing
arm so that it is always horizontal.
6
Adjust the mounting using the four set screws.
7
Screw in the short link arm between the outer
swing arm mounting and the gate mounting
using M12 bolts and washers.
To Next Page
Loading...
