FAAC DAAB MT - Introduction; Intended Use; Machine Marking; Manufacturer

INSTRUCTION MANUAL MT, MA2, MK2, M10 DRIVE UNIT
5
Introduction
• Intended use
To open and close swing gates, leaf doors and folding doors.
Drive units are intended for use in normal indoor and outdoor environments.
All other use is prohibited.
• Machine marking
Art.no
Ser.no
IP X4
Perstorp, Sweden
www.faac.se
Ratio
Year
e plate must not be removed or made illegible!
e identication plate contains the following information:
• Art.no: Part number
• Ser. no: e serial number of the drive unit (used in all communication with FAAC Nordic AB regarding spare parts).
• Ratio: e gear ratio of the gearbox in the drive unit
• Year: e year in which the drive unit was manufactured.
• IP: e IP rating of the drive unit.
• Manufacturer
FAAC Nordic AB
Box 125
SE-284 22 Perstorp, Sweden
Telephone: +46 435 77 95 00
Fax: +46 435 77 95 29
E-mail: info@faac.se
Website: www.faac.se