Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·103·
This parameter has 16 bits counted from right to left.
Each bit has a function or work mode associated with it. By default, all the bits will be assigned the
value of ·0·. Assigning the value of ·1· activates the corresponding function.
Bit 0. Exponential backlash peak.
The additional command pulse used to make up for the possible leadscrew backlash in movement
reversals may be rectangular or exponential. This bit indicates whether it applies a rectangular
backlash peak (bit=0) or an exponential backlash peak (bit=1).
If the duration of the rectangular pulse is adjusted for low speed, it may be too high for high speed
or not enough for low speed when adjusted for high speed. In this cases, it is recommended to use
the exponential type that applies a strong pulse at the beginning and decreases in time.
Bit 13. Additional pulse only in circular paths G2/G3.
This bit indicates whether the additional pulse of velocity command is applied only on circular paths
G2/G3 (bit=1) or in any other type of movement (bit=0).
STPFILE (P146)
It defines the number of the program where the oscilloscope configuration will be saved. This
program will be saved in the hard disk (KeyCF).
CODISET (P147)
Not being used.
COCYF1 (P148) COCYF2 (P149) COCYF3 (P150) COCYF4 (P151)
COCYF5 (P152) COCYF6 (P153) COCYF7 (P154) COCYZ (P155)
COCYPOS (P156) COCYPROF (P157) COCYGROO (P158) COCYZPOS (P159)
Not being used.
Bit Meaning Bit Meaning
0
Exponential backlash peak.
8
1 9
2 10
3 11
4 12
5 13
Apply the additional pulse with G2 /
G3
6 14
7 15
Default value in all the bits: 0
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Possible values
Integer numbers between 0 and 65535.
Default value: 0
To Next Page
Loading...
