Installation manual
CNC 8035
4.
MACHINE PARAMETERS
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·74·
The available machine parameter tables are:
• General machine parameters.
• Machine parameters for the axes (one table per axis)
• Spindle parameters.
• Serial line parameters.
• PLC Parameters.
• Auxiliary (miscellaneous) M functions.
• Leadscrew backlash Compensation (one table per axis).
• Cross compensation.
To access each one of them, use the softkeys shown at the bottom of the screen.
Some characters appear next to certain parameters indicating when the CNC assumes the new
value assigned to that parameter.
On each table, it is possible to move the cursor line by line using the [] [] keys or page by page
using the Page-up and Page-down keys.
Abbreviations used in this manual
The manual uses the following abbreviations to identify the type of machine parameter.
Operation with parameter tables
Once one of the table lines has been selected, the user can move the cursor over this line by means
of the [] [] keys .
It is also possible to perform other functions by using the following keys:
Character Type of update
// It is necessary to press the keystroke sequence: [SHIFT] + [RESET] or turn the
CNC off and back on.
/ Just do a reset.
The rest of the parameters (those unmarked) will be updated automatically, only
by changing them.
Abbreviation Machine parameter Example
g.m.p. General machine parameter. g.m. p. CUSTOMTY (P92)
a.m.p. Axis machine parameter. a.m.p. AXISTYPE (P0)
s.m.p. Spindle machine parameter. s.m.p. MAXGEAR1 (P2)
plc.m.p. PLC machine parameter. plc.m.p. WDGPRG (P0)
Key Function
[CL] Deletes characters.
[INS] Switches between insert and overwrite (replace) writing modes.
[CAP] Switches between upper case and lower case letters; when the CRT shows CAP, it
will indicate that the upper case mode has been selected.
Make sure this mode is selected since all characters entered in these tables must
be upper case.
[ESC] Quits line editing.
[ENTER] Assumes the edited line and ends the editing of the line.
To Next Page
Loading...
