Installation manual
CNC 8035
CONCEPTS
Movement with an electronic handwheel
5.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·191·
5.3.1 Standard handwheel
General handwheel.
1. Select the axis to be jogged.
Press one of the JOG keys of the axis to be jogged. The selected axis will be highlighted.
When using a Fagor handwheel with an axis selector button, the axis may be selected as follows:
• Push the button on the back of the handwheel. The CNC select the first axis and it highlights it.
• When pressing the button again, the CNC selects the next axis and so on in a rotary fashion.
• To deselect the axis, hold the button pressed for more than 2 seconds.
2. Jog the axis.
Once the axis has been selected, it will move as the handwheel is being turned and in the
direction indicated by it.
Individual handwheels.
Each axis will move as the corresponding handwheel is being turned according to the switch position
and in the direction indicated by it.
Simultaneous handwheels.
The machine may have a general handwheel and up to 3 individual handwheels associated with
each axis. The individual handwheels have priority over the general handwheel. So, if an individual
handwheel is moving, the general handwheel will be ignored.
To Next Page
Loading...
