Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·105·
If assigned a value smaller than the real one, the machine will vibrate and if assigned a value greater
than the real one the machining slows down. The value of this parameter may be calculated as
follows:
1. Execute in G91 and G51 E0.1 a program made up of lots of blocks (at least 1000) with very short
moves; for example X0.1 Y0.1 Z0.1.
2. Measure the program execution time, making sure that the machine does not vibrate. Divide the
execution time by the number of blocks executed and assigned the resulting value (in
microseconds) to this parameter.
3. To optimize the parameter, decrease the calculated value and execute the same program until
the machine starts vibrating. To avoid damaging the machine, it is recommended to start the
execution with the feedrate override switch low and increase its value gradually.
4. We recommend the use of the oscilloscope function and verify that the internal variable VLOOKR
remains constant which means that there is no vibration. From the oscilloscope, it is possible
to change the value of parameter TLOOK, but the new value is only assumed when executing
function G51 from the program.
MAINTASF (P162) CAXGAIN (P163)
Not being used.
TOOLMATY (P164)
When using a non-random tool magazine (e.g. a turret), it indicates how many tools may be assigned
to each turret position.
When defined with a ·0· value in a non-random magazine, the tools must be placed in the tool
magazine table in the pre-established order (P1 T1, P2 T2, P3 T3, etc.).
MAXOFFI (P165)
Tool wear offsets may be modified from tool inspection mode. This parameter indicates the
maximum amount of wear that may be entered for "I" (it is programmed in mm or in inches).. It is
defined in diameter at the lathe model.
Default value: 0.5
MAXOFFK (P166)
Tool wear offsets may be modified from tool inspection mode. This parameter indicates the
maximum amount of wear that may be entered for "K" (it is programmed in mm or in inches)..
Default value: 0.5
Value Meaning
0 One tool per position. (P1 T1, P2 T2, etc.).
1 The tool can occupy any position.
Default value: 0
To Next Page
Loading...
