Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Axis parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·130·
When using linear encoders with distance-coded reference marks (I0), set a.m.p. I0CODI1 (P68)
and I0CODI2 (P69).
Tenths:
It defines whether it stops smoothly or not when detecting the reference mark of the axes or not.
When setting the smooth stop, parameters "DERGAIN" and "FFGAIN" should be set to zero.
ABSOFF (P53)
The CNC takes this parameter into account when a.m.p. I0TYPE (P52) has been set with a value
other than 0.
Linear encoders having a distance-coded reference mark indicate the machine position with respect
to the "zero" of the linear encoder.
In order for the CNC to show the position of the axes with respect to the machine reference zero
(home), this parameter must be assigned the position value (coordinate) of the machine reference
zero (point "M") with respect to the "zero" of the linear encoder (C).
MINMOVE (P54)
This parameter has to do with the axis logic outputs "ANT1" through "ANT3".
If the axis move is smaller than the value indicated by this a.m.p. MINMOVE (P54), the corresponding
axis logic output "ANT1 through "ANT3" goes high.
ROLLOVER (P55)
The CNC takes this parameter into account when the axis has been set as rotary "AXISTYPE (P0)=2
or 3". It indicates whether the rotary axis is Rollover or not.
Value Meaning
0x Normal stop on I0.
1x Smooth stop on I0.
Possible values
Within ± 99999.9999 millimeters.
Within ±3937.00787 inches.
Default value: 0
Possible values
Within ±99999.9999 degrees or millimeters.
Within ±3937.00787 inches.
Default value: 0
Value Meaning
NO It is NOT Rollover.
YES It is Rollover.
Default value: YES
To Next Page
Loading...
