Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Spindle parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·152·
M19TYPE (P43)
This parameter sets the type of spindle orient (M19) available.
It indicates whether the spindle must be homed when switching from open to closed loop or it is
enough to home it once on power-up.
DRIBUSID (P44)
It indicates the address of the digital drive (CAN) associated with the spindle. It corresponds with
the value of the drive's rotary switch (address, device select).
It is recommended (not necessary) that the Can addresses of the various axes and spindles be
consecutive and start from number ·1· (the address of the CNC is always ·0·). For example, with
3 CAN axes and 1 CAN spindle, the values of this parameter must be 1, 2, 3 and 4.
OPLACETI (P45)
When working in open loop (M3, M4) spindle command variations may be in a step or in a ramp.
This parameter indicates the duration of the ramp in milliseconds for the maximum "S". If
OPLACETI=0, it will be in a step.
SMOTIME (P46)
Sometimes the axis does not respond as desired on particular movements (handwheel movements,
etc.).
In these cases, the response of the spindle may be smoothed by applying a filter to the speed
changes.
Value Meaning
0 When switching from open loop to closed loop.
1 Once after power-up.
Default value: 0
Value Meaning
0 Analog spindle.
1 - 8 Address of the digital drive.
Default value: 0
Possible values
Integers between 0 and 65535 ms.
Default value: 0 (in steps).
To Next Page
Loading...
