Fagor 8035-T - Page 16

CNC 8035
·16·
Version history (M)
Software V13.01x December 2006
Software V13.02x March 2007
Software V15.01 May 2007
Software V15.11x March 2008
List of features Manual
Display of PLC or CNC messages in Russian and Chinese. INST
New FAGOR filters. INST
Leadscrew backlash compensation. Compensation peak cutting criterion. INST
Home search on Gantry axes (managing two home switches). INST
Automatic spindle homing with the first M3/M4. OPT
Allow two "switched" axes to have different gear ratios. INST
Look-Ahead. Angle below which, it machines in square corner mode. PRG
Teach-in. Execution of the edited block. OPT
Improvements to the oscilloscope and direct access from jog and execution modes. OPT
Editing on hard disk (KeyCF) OPT
Data safety backup. Backup - Restore. OPT
New set of gains and accelerations. INST
Withdraw or skip a drilling or mill type threading cycle. INST / PRG
MSGFILE: Number of PLC messages and errors expanded to 255 and 128 respectively. INST / OPT
Faster rigid tapping without sending M functions to the PLC. INST
List of features Manual
Tool inspection. Resume the interrupted cycle. OPT / PRG
List of features Manual
Do not execute a program sent via DNC until pressing START. INST
Select the set of gains and accelerations to be used in a home search. INST
Prevent motion blocks from being executed in square corner mode. INST / PRG
There are now more zero offsets. PRG
G86. Boring with rapid withdrawal and spindle orientation. PRG
The labels can now have 8 digits. PRG
Maintain the longitudinal axis when changing the work plane. INST / PRG
Editing on hard disk (KeyCF) on CNC's without memory expansion. OPT
List of features Manual
Spindle home search on the next revolution after detecting that the home switch has been
pressed.
INST
Defining a helical interpolation without programming the final coordinate of the axes of the plane. PRG
Starting the CNC up while FAGOR filters are active. INST
Larger numeric format to define the arc center in a G2/G3. PRG
Monitoring the offset between the spindle and the longitudinal axis during rigid tapping. INST / OPT
Hysteresis in the reversal movement compensation command. INST
G210. Bore milling cycle. PRG
G211/G212. Thread milling cycles. PRG
Manual part centering without a probe. OPT
New default value for a.m.p. INPOSW2 (P51). INST
Setting the CNC in Turkish. INST