Installation manual
CNC 8035
13.
PLC PROGRAMMING EXAMPLE
Main module.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·420·
DFU I-SIMULA = SET M120 = ERA M121 126
Whenever the operator requests the simulation (I-SIMULA), marks M120 through M126 must be
activated....
= MOV PLCKEY KEYBOARD = CNCWR (KEYBOARD, KEYSRC, M100)
.. indicate to the CNC that, from now on, the keys will be coming from the PLC (PLCKEY)
= MOV MAINMENU KEYCODE = SET SENDKEY
... and send the code for the "MAIN MENU" key.
M120 AND SENTOK = RES M120 = RES SENTOK = SET M121
If the previous key was sent out successfully (SENTOK), flags M120 and SENTOK will be turned
off, the flag for the next stage (M121) is activated ....
= MOV SIMULATE KEYCODE = SET SENDKEY
... and the code for the SIMULATE key (F2) is sent out.
M121 AND SENTOK = RES M121 = RES SENTOK = SET M122
If the previous key was sent out successfully (SENTOK), flags M121 and SENTOK will be turned
off, the flag for the next stage (M122) is activated ....
= MOV KEY1 KEYCODE = SET SENDKEY
... ...and the code for the "1" key is sent out.
M122 AND SENTOK = RES M122 = RES SENTOK = SET M123
If the previous key was sent out successfully (SENTOK), flags M122 and SENTOK will be turned
off, the flag for the next stage (M123) is activated ....
= MOV KEY2 KEYCODE = SET SENDKEY
... ...and the code for the "2" key is sent out.
M123 AND SENTOK = RES M123 = RES SENTOK = SET M124
If the previous key was sent out successfully (SENTOK), flags M123 and SENTOK will be turned
off, the flag for the next stage (M124) is activated ....
= MOV ENTER KEYCODE = SET SENDKEY
... ...and the code for the "ENTER" key is sent out.
M124 AND SENTOK = RES M124 = RES SENTOK = SET M125
If the previous key was sent out successfully (SENTOK), flags M124 and SENTOK will be turned
off, the flag for the next stage (M125) is activated ....
= MOV THEOPATH KEYCODE = SET SENDKEY
... and the code for the "THEORETICAL PATH" (F1) is sent out.
M125 AND SENTOK = RES M125 = RES SENTOK = SET M126
If the previous key was sent out successfully (SENTOK), flags M125 and SENTOK will be turned
off, the flag for the next stage (M126) is activated ....
= MOV START KEYCODE = SET SENDKEY
... and the code for the START key is sent out.
M126 AND SENTOK = RES M126 = RES SENTOK
If the last key was sent out successfully (SENTOK), flags M126 and SENTOK will be turned off....
To Next Page
Loading...
