Installation manual
CNC 8035
CNC CONFIGURATION
CNC structure
1.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·45·
Connector X2 Digital inputs (I1 to I16) and digital outputs (O1 to O8)
It is a 37-pin normal density SUB-D type female connector.
Connect both 24V and 0V of the power supply used for these inputs and outputs must be connected
to pins 18 and 19 (for 0V) and pins 1 and 20 (for the 24V) of the connector.
Since the response time of the emergency signal must be very short, the CNC has
assigned input I1 for this purpose; thus, the CNC will treat this input immediately
regardless of how the PLC program uses it.
The emergency output, which coincides with O1 of the PLC, will be activated (change
from logic level 1 to 0) when an ALARM or ERROR occurs at the CNC or when the
PLC output O1 is set to 0 (logic level 0).
Pin Signal and function
1
2
3
4
5
24 V
O1
O3
O5
O7
External power supply.
/ Emergency output.
6
7
8
9
10
- - -
- - -
- - -
- - -
I1
11
12
13
14
15
I3
I5
I7
I9
I11
16
17
18
19
I13
I15
0 V
0 V
External power supply.
External power supply.
20
21
22
23
24
24 V
O2
O4
O6
O8
External power supply.
25
26
27
28
29
- - -
- - -
- - -
- - -
I2
30
31
32
33
34
I4
I6
I8
I10
I12
35
36
37
I14
I16
Chassis Shield.
To Next Page
Loading...
