Installation manual
CNC 8035
CNC CONFIGURATION
CNC structure
1.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·49·
Connector X8 For connecting the outputs for the velocity command of the axes
9-pin normal density SUB-D type female connector.
The cable shield must be connected to the metallic hood at each end.
The axis nomenclature is set when setting machine parameters AXIS1 (P0) to AXIS4 (P3).
Pin Signal and function
1
2
3
4
5
Chassis
Cons 1
Cons 2
Cons 3
Cons 4
Shield.
Velocity command output for the first axis.
Velocity command output for the second axis.
Velocity command output for the third axis.
Not being used
6
7
8
9
GND
GND
GND
GND
Velocity command reference signals.
To Next Page
Loading...
