Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·90·
When the beginning or the end of the compensation takes place in a different plane (there is an
intermediate vertical movement) and with angle greater than 270º, one should be analyze the CNC's
behavior as shown next:
• At the beginning of the compensation, the tool should be positioned before penetrating into the
part. The additional block must be executed in the upper plane and, consequently, together with
the first block (COMPTYPE=00).
• At the end of the compensation, the tool should withdraw from the part without penetrating into
it. The additional block must be executed in the upper plane and, consequently, together with
the second block (COMPTYPE=10).
COMPTYPE = 00 COMPTYPE = 10
Executing block by block (single block
mode), the first movement ends at
point "B".
Executing block by block (single block
mode), the first movement ends at
point "A".
To Next Page
Loading...
