Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·92·
DIRESET (P77)
It is used on the lathe model CNC. It indicates whether the RESET is effective with or without a
previous CYCLE STOP.
If DIRESET=YES, the CNC first carries out an internal CYCLE STOP to interrupt program execution
and, then, executes the RESET.
Obviously, if it is performing a threadcutting or similar operation, not admitting a CYCLE STOP, it
will wait for the operation to be concluded before interrupting the program.
PLACOMP (P78)
Not being used.
MACELOOK (P79)
When using "Look-Ahead" the operator sets the percentage of acceleration being applied in Look-
Ahead by means of function G51.
With g.m.p. MACELOOK (P79) the OEM can limit the maximum percentage of acceleration that the
user may set with G51.
MPGCHG (P80) MPGRES (P81) MPGNPUL (P82)
These parameters must be used when having an electronic handwheel to jog the axes.
MPGCHG (P80)
Parameter MPGCHG (P80) indicates the turning direction of the electronic handwheel. If correct,
leave it as is. Otherwise, select YES is there was a NO before or vice versa.
MPGRES (P81)
Parameter MPGRES (P81) indicates the counting resolution of the electronic handwheel and
depends on the display format selected for the corresponding a.m.p. DFORMAT (P1).
Value Meaning
YES The CNC accepts the RESET any time.
NO Only if the STOP condition occurs.
Default value: NO
Possible values
Integer numbers between 0 and 255.
Default value: 0 (there is no limit)
Possible values
NO / YES.
Default value: NO
Possible values
0, 1 and 2.
Default value: 0
To Next Page
Loading...
