ACSD-72/80 Digital Brushless AC Servo Drive system - Ref.1609
The drive is carrying out a task that overheats the power devices. Stop the system for
several minutes and decrease the effort demanded from the drive.
The motor has overheated. The motor temperature measuring cables (position sensor
cable) or the temperature sensor itself are defective. The application may be
demanding high current peaks. Stop the system for several minutes and decrease the
effort demanded from the drive. Cool the motor.
E.106 Extreme temperature at the heatsink (of the IGBT's)
E.108 Motor overheated
E.200 Overspeed
The motor speed has exceeded the
value of SP10 in a 12%.
Bad cabling of the position sensor
or of the motor power.
The velocity loop is adjusted wrong.
Decrease the speed overshoot in
the system response.
E.201 Motor overload
E.202 Drive overload
Time
IF t1<GP3 THE AFTER GP9 MOTOR TORQUE ON=0;
ELSE [MOTOR TORQUE ON=0 AND E.004]
SV2
t1
GP9
SP42
E.200
1.12 x
Rated
Motor
Speed
Time
Speed
Rated
Motor
Speed
SV2
To Next Page
Loading...
