Fancom Aura 14 User Manual

Aura 14
User settings
7
 Dial 2  
Readout of the control value (left) and a readout of the actual ventilation.
Readout of the actual position of the vortex damper.
Readout of the actual position of the air inlet.
Readout of the active additional fans.
There are 10 bending points. At a bending point start by entering the day number; the settings at this bending
point apply to this day number.

Readout of the bending points of the curve (maximum 10).
Setting of the day on which the new curve values must apply.
Setting of the curve value for setpoint heating.

Fancom Aura 14 Specifications

General

Brand	Fancom
Model	Aura 14
Category	Controller
Language	English