F&P SleepStyle Auto - Cleaning

F&P SleepStyle Product Technical Guide | 68
Clinician Guide – Page 26
A-26
10.2.1 CLEANING
DEVICE
1. Wipe the exterior of the device and the
chamber housing with a clean, damp (not
dripping) cloth and warm soapy water using a
mild dishwashing detergent.
2. Leave to dry out of direct sunlight or heat.
WATER CHAMBER, CHAMBER SEAL,
STANDARD BREATHING TUBE, OUTLET
SEAL AND ELBOW
1. Hand-wash these accessories in a tub of
warm, soapy water with a mild dishwashing
detergent. Ensure all visible soil is removed.
2. Rinse thoroughly in a tub of clean water for 30
seconds. Ensure that all soap residue has been
removed.
3. Repeat the rinsing process again, using clean
water.
4. Hang the standard breathing tube, with both
ends pointing to the floor, to dry away from
direct sunlight or heat.
5. Leave the water chamber, chamber seal, outlet
seal and elbow to dry out of direct sunlight or
heat.
Note: If dirt remains inside the standard breathing
tube after rinsing, use a soft, non-metallic brush, to
remove it. Rinse the tube again. If the dirt cannot
be removed, the standard breathing tube should
be replaced.
ENGLISH